All posts
Corrosion protection26 August 2026

Why surface preparation decides how long your coating lasts

Blasting and painting in the corrosion protection division

A coating does not stick to steel the way glue sticks to paper. It grips a microscopic profile of peaks and valleys in the surface. Create that profile properly and a system lasts for years; skip it and even an expensive coating will lift, blister and sheet off long before it should.

The usual culprit is mill scale. Hot-rolled steel comes out of the mill with a thin, dark, brittle oxide layer bonded loosely to the surface. Paint applied over mill scale is not bonded to steel at all. It is bonded to a layer that is already in the process of letting go. Moisture gets underneath, the scale lifts, and the coating comes with it.

Abrasive blasting solves both problems at once. It strips scale, rust and old coatings back to clean metal, and the abrasive media leaves exactly the surface profile the primer needs. The standard the job is blasted to, and the profile depth achieved, should be specified rather than assumed.

Timing matters as much as the blast itself. Freshly blasted steel is chemically bare and starts to flash-rust within hours in humid coastal air. The gap between blasting and priming needs to be short and controlled, which is a practical argument for having blasting and coating happen in the same facility rather than on opposite sides of a transport leg.

None of this is visible in the finished job. A badly prepared structure and a properly prepared one look identical on handover day. The difference shows up in year three, which is exactly why it is worth asking a fabricator what standard they blast to before you place the order rather than after.

Drawings ready? So are we.

Send us your scope and we will come back with a costed, schedulable quotation.

Request a Quote